How to make a wax seal stamp
A wax seal stamp is a brass die on a handle, pressed into melted wax. The die needs deep, bold shapes — a wax seal is a physical impression, so fine detail that works on paper will vanish in wax. The technique matters as much as the artwork.
1Design bold, not detailed
Wax flows and cools fast. Lines under about 1 mm disappear. Text below 8 pt fills in. Use a single strong central motif and, if you need lettering, keep it to a short word or initials on the curved top. A wax seal is read at arm's length, so simple beats clever.
2Mirror the artwork
The die presses into wax, so the design must be mirrored or every letter will come out backwards. If you order a custom die, tell the maker it is for a seal — they mirror it as standard, but say so. If you are producing the artwork yourself in a design program, flip horizontally before sending.
3Get the die made in brass
Wax seal dies are machined or laser-engraved brass, typically 20–30 mm across. They cost more than rubber because brass has to hold up to repeated heat. Send SVG or PDF at final size. There is no way to print a wax seal — this step cannot be skipped if you want real wax.
4Melt the wax properly
Use a melting spoon over a low flame, or a wax gun for volume. The wax is ready when it flows like thick honey — too hot and it burns and darkens, too cool and it sets before the die arrives. Stir gently; bubbles in the wax become pits in the seal.
5Press and hold for three seconds
Pour a pool about 25 mm across onto the paper, wait two seconds for the surface to skin over, then press the die straight down and hold for three seconds. Lifting early is the most common failure — the wax pulls away with the die and leaves a smeared edge.
6Release without rocking
Lift the die straight up. If it sticks, the wax was too cool when you pressed. Let the seal cool fully before moving the document — warm wax smears under a thumb.
The numbers
| Typical die size | 20–30 mm |
|---|---|
| Minimum line width in wax | ≈1 mm |
| Minimum text size | ≈8 pt |
| Hold time | ≈3 seconds |
Questions people actually ask
Can I make a wax seal without a brass die?
Not a real one. Wax seals are physical impressions, so you need a die. You can design the artwork yourself and have it made — that is the part our editor is useful for.
Should the artwork be mirrored?
Yes. The die presses into wax, so the design has to be flipped horizontally or the text comes out backwards. Professional die makers mirror as standard, but confirm it.
Why does my wax seal have a smeared edge?
You pressed too early or lifted too soon. Wait for the wax surface to skin over, press straight down, hold three seconds, lift straight up.
Make it now
The editor runs in the browser — no account, no install. Pick a template, type your text, and download a file that prints at exactly the millimetre size you chose.